- Only £8.31 – 1 litre
- Only £38.57 – 5 Litres
Availability: In stock
Shipping: Via Courier. Please call for a quote
Call us for a quote: 0844 858 2877
SUITABLE FOR INTERIOR & EXTERIOR USE.
Effective for removing, oil, grease, ingrained dirt, grime and old wax layers. Suitable for use on travertine, limestone (including Jura), terracotta, quarry tiles, slate, sandstone, marble, concrete, brick, external paving, grouting and glazed ceramic wall and floor tiles.
IMPORTANT: Test the solution on an inconspicuous area before general application. Any alkalinity remaining on surfaces treated with this product should be completely neutralised. This may be done with a little clean water applied by sponge.
DIRECTIONS FOR USE:
In mild cases and on absorbent tiles: Dilute 1 part Tiletech Grime Remover in 10 parts warm water. Apply with a cloth or mop. Wipe off thoroughly with a clean damp cloth.
In more severe cases: Dilute 1 part Tiletech Grime Remover in 3 parts warm water. Apply liberally, spreading over surface of tiles. If necessary agitate with a scrubbing brush. Leave to react for 5-10 minutes, keeping wet with additional Tiletech Grime Remover solution. Agitate surface again, mop up and rinse thoroughly with clean water.
In extremely severe cases: Use undiluted and agitate with scrubbing brush if necessary. Neutralise treated surface with clean water after use.
In mild cases – approximately 50m2
In more severe cases – approximately 20m2
In extremely severe cases – approximately 5-10m2
This product should not be used for every day cleaning of floors or walls that have been sealed.
This information is offered without guarantee. This material should be used so as to take into account of the local conditions and the surfaces treated. In case of doubt, the product should be tried out in an inconspicuous area.
Please call 0844 858 2877 if you require any additional information on products.